Trying Out The Instrument; Selecting The Channels; Setting The Output Voltage And Current Limit - R&S NGA100 Series Getting Started

®
R&S NGA100
5

Trying Out the Instrument

This chapter describes some basic functions that you can perform with the R&S
NGA100.
5.1

Selecting the Channels

To select a channel, press the corresponding channel key. The key illuminates.
5.2

Setting the Output Voltage and Current Limit

To set the output voltage and current limit via Live-Mode:
1. Long press the rotary knob to enter into editing mode.
By default, the voltage at channel 1 is selected.
2. Use arrow keys to select the desired parameter (voltage or current).
3. Rotate the rotary knob to adjust value.
4. To exist Live-Mode, press the rotary knob.
Alternatively:
1. Press [Voltage] or [Current] key on the front panel.
2. For the two-channel R&S NGA100, press the desired channel key to activate
the respective voltage or current limit setting of that channel. The value on the
respective channel becomes editable and is positioned by a blue cursor.
3. Press the [Left] or [Right] arrow key to move the cursor.
4. Press the [Up]/[Down] arrow key or turn the rotary knob to change the value.
The new value registers immediately.
Getting Started 5601.8902.02 ─ 06
Setting the Output Voltage and Current Limit
Trying Out the Instrument
23