Table of Contents
Advertisement
www.allice.de
®
R&S
NGE100B
6.5.3 Firmware Update
6.5.4 HCOPY
6.5.5 Channel Selecting
User Manual 5601.1343.02 ─ 02
DIAGnostic:SERVice:FWUP <arg0>
Starts instrument firmware update remotely.
For more information, see
Parameters:
<arg0>
Example:
DIAGnostic:SERVice:FWUP "NGE100FWRelease.tar.gz.enc"
Usage:
Setting only
HCOPy:DATA?
This command queries current screen content. BMP format is supported.
Return values:
<arg0>
Usage:
Query only
HCOPy:SIZE:X?
This command returns the horizontal expansion of the screenshots.
Return values:
<arg0>
Usage:
Query only
HCOPy:SIZE:Y?
This command returns the vertical expansion of the screenshots.
Return values:
<arg0>
Usage:
Query only
INSTrument:NSELect <arg0>
This command defines or queries the numeric selection of a channel. Each channel of
the power supply is considered as separate "instrument", which is required by the SCPI
standard.
Chapter 5.7.6, "Updating the
Allice Messtechnik GmbH
Remote Control
Remote Control - Commands
Firmware",
on page 56.
79
Advertisement
Table of Contents
