Table of Contents
Advertisement
www.allice.de
®
R&S
NGE100B
User Manual 5601.1343.02 ─ 02
Parameters:
<Power>
{<Voltage> | MIN | MAX}
<Voltage>
Set the OPP value in the range of 0 W up to 32 W (adjustable in
100 mW steps)
MIN
Set the OPP value to minimum.
MAX
Set the OPP value to maximum
Default unit: W
Example:
INST OUT1
POW:PROT:LEV 5
Set the OPP value of channel 1 to 5 W.
POW:PROT:LEV? -> 5
Return the selected channel OPP value.
[SOURce:]POWer:PROTection:TRIPped?
This command queries the OPP tripped status of the previous selected channel
Return values:
<arg0>
1 | 0
1
OPP is tripped.
0
OPP is not tripped.
Example:
INST OUT1
POW:PROT:TRIP? -> 0
OPP state of Ch 1 has not tripped.
Usage:
Query only
[SOURce:]POWer:PROTection[:STATe] <arg0>
This command defines or queries the OPP state for the previous selected channel.
Parameters:
<arg0>
ON | OFF | 1 | 0
ON | 1
OPP is activated.
OFF | 0
OPP is deactivated.
Example:
INST OUT1
POW:PROT ON
OPP of Ch 1 is activated.
POW:PROT?
Return the OPP state of the selected channel.
Allice Messtechnik GmbH
Remote Control
Remote Control - Commands
87
Advertisement
Table of Contents
