Table of Contents
Advertisement
www.allice.de
®
R&S
NGE100B
User Manual 5601.1343.02 ─ 02
Depending on the network capacities, the TCP/IP address information for the instru-
ment can be obtained in different ways.
●
If the network supports dynamic TCP/IP configuration using the Dynamic Host
Configuration Protocol (DHCP), and a DHCP server is available, all address infor-
mation can be assigned automatically.
●
Otherwise, the address must be set manually. Automatic Private IP Addressing
(APIPA) is not supported.
By default, the instrument is configured to use dynamic TCP/IP configuration and
obtain all address information automatically. This means that it is safe to establish a
physical connection to the LAN without any previous instrument configuration.
Risk of network errors
Connection errors can affect the entire network. If your network does not support
DHCP, or if you choose to disable dynamic TCP/IP configuration, you must assign valid
address information before connecting the instrument to the LAN. Contact your net-
work administrator to obtain a valid IP address.
1. Connect a LAN cable to the LAN port (see
port).
2. Configure the connection settings manually or have the network configure the set-
tings for you via menu. By default, automatic configuration is set in the instrument.
For manual configuration, configure the settings as follows:
a) Select "Interface > Ethernet" menu item.
The R&S NGE100B displays the "Ethernet" dialog. See
Figure 5-20: Ethernet dialog
b) Select "DHCP & Auto-IP" for "IP Mode".
c) Enter the "IP Address".
d) Enter the "Subnet Mask".
e) Enter the "Default Gateway".
f)
Select "Apply" to complete the configuration.
g) Press Menu key to exit the dialog.
Allice Messtechnik GmbH
Instrument Functions
Connecting to a Network
Figure 4-4
for the location of the LAN
Figure
5-20.
49
Advertisement
Table of Contents
