Mts - Replacing Site Controller; Mts - Configuration Backup - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
MTS – Replacing Site Controller
Process 8-1 MTS – Replacing Site Controller
1
2
3
4
5
6
7
8
MTS - Configuration Backup
Process 8-2 MTS - Configuration Backup
1
2
3
MTS - Setting Up a Terminal
Procedure 8-4 MTS - How to Set Up a Terminal
Load appropriate version of MTS Service Software onto PC by double clicking on setup.EXE
1
and following installation instructions until installation is complete.
Open MTS Service Software (TESS) application and when login screen is displayed, check
2
that the release version is correct.
Enter password.
3
6802800U74-N September 2009
Check the MTS restoration impact. See
Back up the Site Controller configuration (if possible). See
on page 8-19.
Replace the Site Controller FRU. See
See "MTS - Restoring the Site Controller Software" on page
Configure CAN bus. See
Configure Cooling fans. See
Load Ki's into MTS. See
Check the MTS post-restoration checks. See
on page 8-39.
Set up a terminal and TESS application. Connect to MTS. See
on page 8-19.
Back up the Site Controller configuration. See
Configuration" on page 8-20.
If necessary, view and edit configuration file. See
File" on page 8-21.
Table 8-7, "MTS - Restoration Impact," on page
"MTS - Replacing Site Controller FRU" on page
"MTS - Configuring CAN Bus" on page
"MTS - Configuring Cooling Fans" on page
"MTS - Loading Ki's Into MTS" on page
"MTS - Site Controller Post-Restoration Checks"
"MTS - Backing Up the Site Controller
"MTS - Viewing and Editing Configuration
MTS – Replacing Site Controller
"MTS - Configuration Backup"
8-23.
8-33.
8-34.
8-34.
"MTS - Setting Up a Terminal"
8-18.
8-21.
8-19