Mts - Uploading The Site Receipts (Locally); Mts - Uploading The Site Receipts (Remotely Using Gsm) - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS - Uploading the Site Receipts (Locally)

Procedure 8-20 MTS - How to Download Ki's from KVL to Site Controller/BRC (Continued)
Check if the MTS is in correct security class. Login to the Site Controller, and then enter
14
status sec and status keys commands.
Check MTS returns to Wide Area Trunking and that no alarms are active.
15
Upload the site receipts. Depending on method you want to use, continue to:
16
MTS - Uploading the Site Receipts (Locally)
Procedure 8-21 MTS - How to Upload the Site Receipts (Locally)
If no GSM connectivity is available then disconnect equipment and travel to switch site.
1
Using a null modem cable from the AuC COM port 1 to the KVL device select Au/Prc from the
2
KVL main menu, then DIRECT, then RS232.
Result: The AuC event log will display successful connection from the KVL before allowing
the upload/download process to start.
The KVL will both send the Site Ki receipts to the AuC automatically.
3
Allow approximately one minute for the process to complete.
4
Upon completion the AuC event log will display a success message and the KVL will also
5
acknowledge successful download by emitting an alternating hi/low tone and displaying message
Download Successfully Completed.
Press OK button on KVL.
6
Check on KVL that site is no longer listed by selecting List and then View.
7
Check on AuC that icon for site is now green and no errors are reported in the event window
8
for the site.

MTS - Uploading the Site Receipts (Remotely using GSM)

Procedure 8-22 MTS - How to Upload the Site Receipts (Remotely Using GSM)
1
2
3
8-38
If a base station is not supporting the correct security class (2 or 3) reset the Site
Controller and repeat this step.
"MTS - Uploading the Site Receipts (Locally)" on page 8-38
•
"MTS - Uploading the Site Receipts (Remotely using GSM)" on page 8-38
•
If GSM connectivity is available then log in to KVL device.
Connect GSM to KVL through modified adapter (Motorola phones only).
On the KVL select Au/PrC from the main menu, then MODEM, then RS232.
.
Chapter 8: Site Controller
6802800U74-N September 2009