Base Radio - Indicators And Connectors; Table 10-1 Base Radio - Led Indicators - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Base Radio - Indicators and Connectors

Base Radio - Indicators and Connectors
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■

Table 10-1 Base Radio - LED Indicators

#
LED 1
LED 2
LED 3
LED 4
LED5
LED6
LED7
LED8
10-8
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
LED/Port name Type
Tx
Red/Green
Aux Red/Green
Status Red/Green
BR Alarm Red/Green
SC 1 Green
SC 1
Yellow
SC 2 Green
SC 2 Yellow
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Controlled by
SW
SW
SW Red LED will
turn on before
SW change any
indication
SW
HW, Enet IC
HW, Enet IC
HW, Enet IC
HW, Enet IC
■ ■ ■ ■
■
■
Indication
BR keying:
• OFF: BR is not keyed
• AMBER: BR is keyed without
service
• GREEN: BR is keyed
• OFF: No alarms
• AMBER: not used
• RED: not used
BR status:
• OFF: Status unknown, power off
• GREEN: BRC main application
is running
• AMBER: Waiting for SWDL –
this is where the BR will wait if
no Site Controller is present
• RED: SW not started, power on
OFF: No alarms
•
• AMBER: BR minor alarm: PA,
Exciter, RX, BRC Reduced
performance
• RED: BR failed: PA, Exciter,
RX, BRC
• OFF: Ethernet link not present
GREEN: Ethernet link present
•
• OFF: Ethernet activity not present
• YELLOW: Ethernet activity
present
OFF: Ethernet link not present
•
GREEN: Ethernet link present
•
• OFF: Ethernet activity not present
• YELLOW: Ethernet activity
present
6802800U74-N September 2009
Chapter 10: Base Radio