Figure 15-8 Tx Connectors On Cavity Combiner - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Procedure 15-4 How to Add an Additional Base Radio to MTS 4 (Continued)
5
6
7
8
6802800U74-N September 2009

Figure 15-8 TX Connectors on Cavity Combiner

Attach the Ethernet cable to the appropriate BR input of the Site Controller according to the
scheme below:
# Note
2 If BR2
6
If BR3
11 If BR4
Index numbers in table above refer to cable connections shown in
At this stage only connect the cable to the Site Controller.
If the Ethernet cable is being wired from a Base Radio in one Module Cage to a Site
Controller in another Module Cage, the Ethernet cable is to be drawn outside of
the Module Cage.
Insert the additional Base Radio by aligning the side rails with the appropriate rail guides inside
the Base Radio chassis.
Gently push the additional module completely into the Base Radio chassis assembly using
the module handle(s). Be careful not to damage any of the cables previously connected when
pushing the Base Radio into position.
Secure the additional module using two TORX screws. Tighten the screws to a torque of 2.7 Nm.
Part no Cable type
3066544B02 Ethernet
cable
3066544B04
Ethernet
cable
3066544B05 Ethernet
cable
How to Install
From To
BR2 / SC1 SC1 / BR2
BR3 / SC1 SC1 / BR3
BR4 / SC1 SC1 / BR4
Figure 15-11.
15-19