Site Controller - Front Panel Indicators (Led); Table 8-1 Site Controller - Front Panel Indicators (Led) - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual

Site Controller - Front Panel Indicators (LED)

Table 8-1 Site Controller - Front Panel Indicators (LED)

LED
LED1
LED2
LED3
LED4
LED5
LED6
6802800U74-N September 2009
LED/Port
Position
Name
Active Front Panel
Mode Front Panel
GPS Front Panel
BTS Alarm Front Panel
Port 1 LED1
BR1
Port 1 LED2
Site Controller - Front Panel Indicators (LED)
Controlled by
SW
Site Controller is active or standby:
• OFF: Site Controller main
• GREEN: E1/X.21 relay energized.
• AMBER: E1/X21 relay not
• RED: Failed Site Controller,
SW Trunking status:
• OFF: Boot up/No
• GREEN: Wide area trunking.
• AMBER: Local site trunking.
SW • OFF: BTS not configured for GPS
• GREEN: GPS locked and BTS
• AMBER Blinking: In training.
• AMBER Solid: GPS Free run
• RED: No GPS signal, no
SW • OFF: No alarms.
• GREEN: Not used.
• AMBER: CAN Bus problems,
• RED: See
HW, Enet switch • OFF: Ethernet link not present.
• GREEN: Ethernet link present.
HW, Enet switch • OFF: Ethernet activity not present.
• YELLOW: Ethernet activity
Indication
application not running.
energized.
replace FRU.
trunking/Standby.
module.
synchronized.
mode synchronized (ETSI spec).
connection to remote GPS, or
non-synchronized mode (ETSI
spec).
External alarms.
Table 13-1, " Site
Controller LED Fault Indications
," on page 13-2
present.
8-5