Fru Replacement Process - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual

FRU Replacement Process

Process 7-8
For a list of available FRUs, see
Process 7-8 Replacing the Expansion Cabinet RX Splitter
1
2
Removing the RX Splitter
Procedure 7-19
Procedure 7-19 How to Remove the RX Splitter
1
2
3
4
5
6
7
8
Reinstalling the RX Splitter
Procedure 7-20
Procedure 7-20 How to Reinstall the RX Splitter
1
2
3
4
5
6
7
6802800U74-N September 2009
outlines the recommended tasks to be performed to replace the Expansion Cabinet RX Splitter.
Appendix A, "Field Replaceable Units
Remove the RX splitter, see
Reinstall the RX splitter, see
describes how to remove RX Splitter.
Remove the door of the cabinet completely.
Remove the four screws holding the front panel.
Loosen the two screws holding the front section of the top panel and slide off the panel.
Loosen the screws fastening the rear section of the top panel and slide off the panel.
Remove the RX cables connected to the back of the RX Splitter.
Loosen the two fastening screws at the front enough to free the mounting bracket.
Slide the RX Splitter out of the cabinet.
Remove the RX Splitter from the bracket and replace with the new unit.
describes how to reinstall the RX Splitter.
Fasten the RX Splitter onto the bracket.
Slide the RX Splitter into the cabinet.
Tighten the two fastening screws at the front.
Connect the RX cables to the back of the RX Splitter.
Slide on the top rear and front panels and fasten these with screws.
Place the front panel back on and screw this into place.
Put the door of the cabinet back on.
Procedure 7-19 on page 7-37.
Procedure 7-20 on page 7-37.
FRU Replacement Process
(FRUs)".
7-37