Table of Contents
Advertisement
2-2 CB3000 Client Bridge Quick Install Guide
Prerequisite Requirements
The following hardware and software resources are required to install and operate a CB3000:
• PC to be used during device configuration. The PC must have an RJ-45 Ethernet port and a CDROM
drive. The PC must be running the following:
• Windows 2000 or XP operating system
• Internet Explore 5.0 (or higher) or Netscape 6.0 (or higher)
• An Access Point (AP) (for infrastructure mode operation) or a networked client (for Ad Hoc mode peer-to-
peer operation).
Verifying the Package Contents
Before installing the CB3000, verify the package contains the following:
• CB3000 Installation Guide (this guide)
• CB3000 Software and Documentation CDROM
• CB3000 Client Bridge (Part No. CB-3000-0010-WWR)
• Ethernet cable
• Power adapter with 5 localized plugs
• Single detachable omni-directional antenna.
• Mounting hardware.
CAUTION: Only qualified and approved antennas can be used with the CB3000.
NOTE: Contact the Motorola Support Center to report any missing or improperly functioning
components.
Verifying the Installation Site
Mounting options for the CB3000 include table top, wall or under a counter mounting using the keyholes and
mounting hardware provided with the unit.
Before installing CB3000, verify the installation site meets the following requirements:
• The Environmental Specifications as defined in the
• The site should have access to a properly rated power source.
• The site should be dry and within 100 meters of the device(s) (hub, telephone, computers, point-of-sale)
to be connected to the CB3000.
• The site should not be near other equipment (transformers, fluorescent lights etc.) that could interfere
with the CB3000's radio transmissions.
• The site should be within 250 ft. of the access point the CB3000 is targeting for association.
"Technical
Specifications" section of this guide.
Hide quick links:
Advertisement
Table of Contents
