Using Ethernet Site Link Retrofit Kit For Mts 4 - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Using Ethernet Site Link Retrofit Kit for MTS 4
Using Ethernet Site Link Retrofit Kit for MTS 4
Unlike the MTS 2, the previous type of MTS 4 Junction Panel has an unused AUX breakout
which will be used, together with the existing E1 connector, for Ethernet Site Link functionality.
Follow Procedure 4-12
connectors on the previous type of MTS 4 Junction Panel.
Procedure 4-12 How to Connect Ethernet Site Link Retrofit Kit for MTS 4
1
2
3
4
4-58
in order to gain Ethernet Site Link functionality from the E1 and AUX
Remove existing E1 cable from E1 connector on Junction Panel.
Connect the open E1 connector on the Junction Panel with the RJ45 coupler (3066562B01).
Bend AUX breakout and insert the second RJ45 coupler (3066562B01).
• For configurations with single Site Controller, follow
Cabling for MTS 4 with Single Site Controller," on page 5-19
Site Link Cabling for MTS 4 with Single Site Controller" on page 5-20
and connections.
• For configurations with dual Site Controller, follow
Cabling for MTS 4 with Dual Site Controller," on page 5-21
Site Link Cabling for MTS 4 with Dual Site Controller" on page 5-22
and connections.
In Table 5-10
Panel is equivalent to Link1 and AUX on old Junction Panel is equivalent to Link2.
and Table 5-11; and Figure 5-10
Chapter 4: Hardware Installation
Table 5-10, "Ethernet Site Link
and Figure 5-10,"Ethernet
for further cabling
Table 5-11, "Ethernet Site Link
and Figure 5-11,"Ethernet
for further cabling
and Figure 5-11 E1 on old Junction
6802800U74-N September 2009