MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Securing Cabinet to a Mounting Plate
Procedure 4-3 How to Secure Cabinet to a Mounting Plate
1
2
3
4
6802800U74-N September 2009
Move the MTS cabinet near to the mounting plate which has been fixed to the floor as described
before.
Bring the MTS in position and lower it onto the mounting plate. Care must be taken not to lower
the MTS onto the locating tabs on the rear of the mounting plate to avoid bending.
Move the MTS from the front to the back ensuring that the leveling feet of the MTS locate in the
corresponding slots in the mounting plate.
Secure the MTS on the mounting plate using the two front security M10 screws. If the leveling
feet are in the lowest position, M10x40 screws must be used. The position of the screws is
shown in
Figure
4-10. Recommended tool: allen wrench for M10, SW8 HEX screws (supplied
with the mounting plate kit).
Figure 4-10 Position of Security Screws
Securing Cabinet to a Mounting Plate
4-15