Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 296

MTS - Backing Up the Site Controller Configuration
Procedure 8-4 MTS - How to Set Up a Terminal (Continued)
Connect a Straight Through Ethernet cable between the LAN port on PC and the Service Access
4
port on the front of the Site Controller. Change your PC IP address to 10.0.253.100, mask
255.255.255.0, gateway 10.0.253.1.
In main window, select Connection and select Connect Telnet New....
5
Result: The Telnet Connection Settings window is opened.
Specify connection settings of 10.0.253.1 in the 'Site IP' box and click OK to establish a
6
connection.
Press Enter and at the
7
characters.
Enter the field password when prompted.
8
Result: You should see an SC> prompt.
Continue to
9
MTS - Backing Up the Site Controller Configuration
Procedure 8-5 MTS - How to Back Up Current MTS Configuration to PC
Select Upload Configuration in TESS application.
1
Result: Window opens showing the Site Controller configuration files for upload.
Ensure that the file that is set to current and next (as indicated by + + ) is highlighted in blue
2
and click OK.
Observe the Site Controller and BR file transfer and when complete, confirm the window showing
3
transfer status displays
When prompted to save the uploaded configuration file, use an appropriate name and click OK to
4
save the configuration file in the default folder.
8-20
In case of redundant Site Controller configuration where second SC (upper) is active
will use subnet .254.
prompt, enter any user name consisting of at least three
User Name
The higher level engineering password may also be used and will return an SC>
prompt.
"MTS - Backing Up the Site Controller Configuration" on page
You may choose to upload the non-current file by selecting it.
Transferred No Errors
You may use the browser to save the config file to a specific folder if preferred.
8-20.
for all files transferred then click OK.
6802800U74-N September 2009
Chapter 8: Site Controller