Table of Contents
Advertisement
MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Base Radio Receiver Configuration
The procedure below can be done locally as well as remotely. The commands to check and
change the BR parameters require the use of BRC Application MMI.
Procedure 6-3 How to Verify Base Radio Parameters
1
2
3
4
5
6
7
6802800U74-N September 2009
Log in to the Base Radio in application mode.
Type get nvm_param rx1 atten_default and press Enter.
Result: The correct setting should be
If no returned parameter value is observed then the parameter is missing. See
the parameter.
Type get nvm_param pa dekey_limit and press Enter.
Result: The correct setting should be
If no returned parameter value is observed then the parameter is missing. See
the parameter.
Type get nvm_param rx1 rx_dc_inj_usl and press Enter.
Result: The correct setting should be
If no returned parameter value is observed then the parameter is missing. See
the parameter.
Type get nvm_param rx1 rx_dc_inj_lsl and press Enter.
Result: The correct setting should be
Type get nvm_param rx1 ad1_scaling6 and press Enter.
Result: The correct setting should be
If no returned parameter value is observed then the parameter is missing. See
the parameter.
Type get nvm_param rx1 rx_fru_config and press Enter.
Result: The setting will depend on the receiver diversity required for the site.
If no returned parameter value is observed then the parameter is missing. See
the parameter.
Base Radio Receiver Configuration
for MTS 4 and
for MTS 2.
0
4
.
6
.
1.5
.
0
.
28.9
Table 6-7
to add
Table 6-7
to add
Table 6-7
to add
Table 6-7
to add
Table 6-7
to add
6-19
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
