Chapter 6: Configuration And Testing; Setup And Testing Overview - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Configuration and Testing
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
The setup and testing procedures covered in this manual are intended to be used in conjunction with
the information provided in
Together, the troubleshooting solutions and testing procedures, provide the necessary information to
isolate failures to a Field Replaceable Unit (FRU) or replaceable part. This helps to keep the system
down time to a minimum by quickly returning the site to normal operation.
All suspected faulty FRUs should be shipped to a Motorola depot facility for servicing or repair.
For a list of available FRUs, see

Setup and Testing Overview

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
The setup and test procedures in this manual are used to test the functionality of the
MTS and help isolate failures to the module level.
The setup and testing procedures are divided into the following sections:
•
•
•
•
6802800U74-N September 2009
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Chapter 13, "MTS Troubleshooting"
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
"Preparation"
"Site Controller Configuration and Verification"
"CAN Bus Configuration"
"Base Radio Configuration and Verification"
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Appendix A, "Field Replaceable Units
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Chapter
6
■ ■ ■
■
■
■
■
and "MMI Commands Manual".
(FRUs)".
■ ■ ■
■
■
6-1