Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 305

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Procedure 8-12 MTS - How to Configure E1 Links
1
2
3
4
5
6802800U74-N September 2009
Verify details of the configuration of E1 connection between MTS and CNE core router. In
particular check how many physical links will be used (one for star-like configuration, two for a
ring) and pattern of timeslots to be used. In case of standard configuration (one E1 site link,
timeslots 1 and 2) no further steps are necessary. If not, go to the next step.
Log in to the Site Controller.
Contact your local Motorola representative or Technical Support to obtain password.
If MTS is connected to the infrastructure with 1 E1 link, PVC1 carried by timeslots X1, X2,...,
PVC2 carried by timeslots Y1, Y2,..., execute the following sequence of MMI commands, SC>:
.e1config -siteLink dual
.e1config -DI off
.e1config -channel 1 -portNo 1
.e1config -channel 2 -portNo 1
.e1config -channel 1 -tsPattern X1 X2 ...
.e1config -channel 2 -tsPattern Y1 Y2 ...
Please note that timeslots assigned to both channels can be identical. Timeslot
pattern can be passed as a list of slot numbers separated with spaces. Several
consecutive timeslots can be also passed in the format X1:XN.
Examples:
.e1config -channel 1 -tsPattern 1:31
assigns all timeslots from 1 to 31 to channel 1
.e1config -channel 1 -tsPattern 1 2 10:15
assigns timeslots 1,2,10,11,12,13,14,15 to channel 1.
If MTS is connected to the infrastructure with 2 E1 links, PVC1 carried by timeslots X1,X2,...,
PVC2 carried by timeslots Y1, Y2,..., execute the following sequence of MMI commands, SC>:
.e1config -siteLink dual
.e1config -DI off
.e1config -channel 1 -portNo 1
.e1config -channel 2 -portNo 2
.e1config -channel 1 -tsPattern X1 X2 ...
.e1config -channel 2 -tsPattern Y1 Y2 ...
For up to 10 MTSs connected in the ring topology (i.e. Core Router 1 -----MTS1-----MTS2--
-....-----MTS10-----Core Router 2) execute the following commands on each MTS in the ring:
.e1config -siteLink dual
.e1config -DI on
.e1config -channel 1 -portNo 1
.e1config -channel 2 -portNo 2
.e1config -channel 1 -tsPattern X1 X2 ...
.e1config -channel 2 -tsPattern Y1 Y2 ...
Timeslots configured for each site in the ring should be different.
MTS - Configuring E1 Links
8-29