Selecting Base Radio Position And Receivers; Figure 6-4 Brc Indicators - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual

Figure 6-4 BRC Indicators

Selecting Base Radio Position and Receivers

The new Base Radio needs to be assigned a position identifier and is performed from the Service port.
MMI commands are used to:
•
•
These operations are described in the following procedures. Use the MMI commands as outlined in the
"MTS Interface Commands" booklet for detailed information on using the MMI commands.
6802800U74-N September 2009
Set the position identifier of the Base Radio within the cabinet.
Set the number of active receivers (diversity) of the new Base Radio.
Selecting Base Radio Position and Receivers
6-15