Base Radio Test Application Software Upgrade (Optional); Transmitter Verification - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual

Base Radio Test Application Software Upgrade (optional)

Procedure 6-6 How to Upgrade to Latest Test Application Software
1
2
3
4
5
6
7
8
9
10
11
12
Transmitter Verification
The transmitter verification procedure verifies the transmitter operation and the integrity of the transmit
path. This verification procedure is recommended after replacing the Base Radio module.
6802800U74-N September 2009
It is important to make sure that this procedure never is used to downgrade the Test Application.
Point 3COM server to the folder containing the BRC Test App software.
Connect a RJ45 cable to the serial port of the PC and the Service port on the Base Radio.
Connect a crossed Ethernet cable to the PC and the SC1 port on BR
Reset BR and enter boot1 mode.
Do not enter testapp mode from here
Type ferase 0x10100000 4M and press Enter.
When prompt returns type ifconfig eth0 address 10.0.253.<CAB><POS> and
press Enter.
When prompt returns type finstall testapp
/tftp/10.0.253.100/R064020ROM.srec and press Enter.
R064020ROM.srec in command above is used as an example. Please indicate
latest released file when entering command.
Result: BRC will reset itself at the end
Enter boot1 mode and then enter test app mode.
Login as factory user in test app mode, type fv -oplatform and press Enter.
On the last line of the output check that the version is R064020 or which ever version was
upgraded to in step 7.
Reset the BR by typing reset -oplatform and press Enter.
Disconnect the service cable from the BR and reconnect the Ethernet cable to LAN 1.
Rerun Procedure 6-5, "How to Verify the Base Radio Software Version Number," on page 6-22
to verify that the latest versions have been installed correctly.
Base Radio Test Application Software Upgrade (optional)
6-23