Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 229

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
Configuring the pm_config
Procedure 6-4
For more information about how to use the pm_config command, refer to MTS Man
Machine Interface Commands Manual.
Procedure 6-4 How to Configure pm_config
1
2
3
6802800U74-N September 2009
explains how to configure pm_config on the Site Controller.
Pm_configuration defines the relationship between RFDS components and Base Radios. If one
cavity in an ATCC measures a high Voltage Standing Wave Radio (VSWR), it results in the decay
of the corresponding Base Radio. A broken antenna or failure on a feeder cable indicates a
bad VSWR on the DPM. It also results in the decay of Base Radios using this DPM.
To set up pm_config for MTS-4 with ATCC and one TX antenna, use the
following commands:
• pm_config br 1 dpm 1
• pm_config br 1 atcc 1 cav 1
• pm_config br 2 dpm 1
• pm_config br 2 atcc 1 cav 2
• pm_config br 3 dpm 1
• pm_config br 3 atcc 2 cav 1
• pm_config br 4 dpm 1
• pm_config br 4 atcc 2 cav 2
To get help, use the following command:SC: pm_config -
If Expansion cabinet is used, pm_config needs to be setup accordingly.
By default, the following commands could be used:
To configure the DPM and ATCC mapping to BR, use the following command:
pm_config [-?]
To configure the ATCC (cavity) to BR mapping, use the following command:
br <br> atcc <atcc> cav <cavity>
• pm_config br 5 dpm 3
• pm_config br 5 atcc 3 cav 1
• pm_config br 6 dpm 3
• pm_config br 6 atcc 3 cav 2
• pm_config br 7 dpm 4
• pm_config br 7 atcc 4 cav 1
• pm_config br 8 dpm 4
• pm_config br 8 atcc 4 cav 2
Configuring the pm_config
6-21