Site Controller - Gps Module - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Site Controller - GPS Module

Procedure 8-1 Site Controller - How to Update the Mapping List with the New Unit TrackID
(Continued)
5
6
Site Controller - GPS Module
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
The GPS module generates a highly accurate timing reference signal within the Base Station. To do this a
proper GPS signal must be provided to the QMA input connector on the Site Controller Front Panel. Refer to
the GPS section in the Technical Specifications chapter of this manual. The Site Controller provides a +5 V dc
supply voltage on the QMA connector. It is intended to be used to provide a voltage supply for active antennas.
8-14
Add new CAN Bus unit to the CAN Bus unit mapping list.
The new unit Track ID is present on the replaced unit label and indicated as Track
ID not mapped in the list shown in
Use can add_mapping <Device> <TrackID>, where <TrackID> is a TrackID of the
new unit and <Device> is the new unit name. Units have the following names: psu X, dpm X,
atcc X, where X denotes a digit between 0 and 3. See example below:
SC> can add_mapping dpm 2 JTH0500102
View the updated mapping list using the can check_mapping command and check that
there are no units labelled as Track ID not mapped or Units are not present.
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
See Chapter 4, "Hardware Installation"
See "MTS - Internal GPS Module Test" on page 8-40
on page 8-41 for procedures on how to verify the internal and external GPS module.
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
for description of external GPS.
step 2.
■ ■ ■ ■
■
■
and "MTS - External GPS Module Test"
6802800U74-N September 2009
Chapter 8: Site Controller