Table of Contents
Advertisement
2 Select and define the network components: the PLC,
XtraDrive-DP, transmission rate, and so on.
Select the hardware components to be used on the PROFIBUS
network, starting with the master (including its specific CPU
and power supply), and then the network (for example,
determining the profile and transmission rate). Once this has
been carried out, you must determine the slave XtraDrive-DP
and its address. It is important to ensure that this is the same as
the address set by the rotary switches on the XtraDrive-DP's
front panel.
The picture below displays the system setup as shown in the S7
SIMATIC Manager:
3 Select the System Parameters module.
NOTE:
The three steps described above must be performed for any application.
Once you have finished setting the system definitions and
configuration, you can continue with the specific application.
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France
Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20
Web : http: www.audin.fr - Email : info@audin.fr
Example of Using XtraDrive-DP
A
PPENDIX
77
E
Advertisement
Table of Contents
