Tim Counter Registers (Tcnth:tcntl) - Freescale Semiconductor MC68HC08KH12 Datasheet

Freescale semiconductor microcontrollers data sheet
Table of Contents

Advertisement

NOTE:
NOTE:

11.9.2 TIM Counter Registers (TCNTH:TCNTL)

MC68HC(7)08KH12
Rev. 1.1
Freescale Semiconductor
Do not set the TSTOP bit before entering wait mode if the TIM is required
to exit wait mode.
TRST — TIM Reset Bit
Setting this write-only bit resets the TIM counter and the TIM
prescaler. Setting TRST has no effect on any other registers.
Counting resumes from $0000. TRST is cleared automatically after
the TIM counter is reset and always reads as logic zero. Reset clears
the TRST bit.
1 = Prescaler and TIM counter cleared
0 = No effect
Setting the TSTOP and TRST bits simultaneously stops the TIM counter
at a value of $0000.
PS[2:0] — Prescaler Select Bits
These read/write bits select either the PTE0/TCLK pin or one of the
seven prescaler outputs as the input to the TIM counter as
shows. Reset clears the PS[2:0] bits.
PS2
PS1
PS0
0
0
0
0
0
1
0
1
0
0
1
1
1
0
0
1
0
1
1
1
0
1
1
1
The two read-only TIM counter registers contain the high and low bytes
of the value in the TIM counter. Reading the high byte (TCNTH) latches
the contents of the low byte (TCNTL) into a buffer. Subsequent reads of
Table 11-2. Prescaler Selection
TIM Clock Source
Internal Bus Clock ÷ 1
Internal Bus Clock ÷ 2
Internal Bus Clock ÷ 4
Internal Bus Clock ÷ 8
Internal Bus Clock ÷ 16
Internal Bus Clock ÷ 32
Internal Bus Clock ÷ 64
Table 11-2
PTE0/TCLK
Advance Information
175

Advertisement

Table of Contents
loading

Table of Contents