ESAB PUA 1 Manual page 54

9.2.3 Remote control
All configurations for remote control apply to all connected wire feeds.
If ANALOGUE1is deselected. this applies to both wire feed units when double feed
units are used.
Place the cursor on the row FORGET OVERRIDE. Press ENTER to view a list of
alternatives.
When the forget changes function is enabled, the original data from the memory
position currently in use is recalled after each welding stop.
In other words, if you make a change relating to the synergic line (for example,
increasing the voltage by 2 V), weld and stop, the voltage change is discarded and
the original data recalled. This can be useful when testing new welding data, for
example.
Configuration for digital remote control
When using digital remote control, specify the type of control to be used--5--program
or 32--program (binary coded). If you have a torch with a 3--program control switch,
choose the 5--program alternative.
If you place the cursor on the row DIGITAL OP and press ENTER, a list is displayed
from which you can choose an alternative.
bu12d04a
MAIN MENU
AUXILIARY FUNCTIONS
CONFIGURATION
REMOTE CONTROLS
MIG--REMOTE CONTROLS
FORGET OVERRIDE
DIGITAL OP:
ANALOG 1:
ANALOG 2:
BINARY CODED
5--PROG.
- - 54 - -
DISABLED
5--PROG
NONE
NONE
QUIT ENTER