ESAB PUA 1 Manual page 55

Configuration for Analogue Remote Control
When using analogue remote control, you should indicate which potentiometer(s)
you will use (maximum 2). This is done in the controller.
The potentiometers are designated ANALOG 1 and ANALOG 2 in the controller and
refer to each individual fixed parameter for the weld process, e.g. voltage (ANALOG
1) and wire feed (ANALOG 2) for MIG.
Position the cursor on the line ANALOG 1 and press
ENTER to call up a list.
It is possible to choose if the potentiometer
ANALOG 1 will be used (VOLTAGE) or if it will not
be used (NONE).
Select the line VOLTAGE and press ENTER
The following
display apppears
If you position the cursor on the line ANALOG 2 and
press ENTER. a list appears.
It is now possible to choose if the potentiometer
ANALOG 2 will be used (WIRE FEED SPEED) or if it
will not be used (NONE).
Select the line WIRE FEED SPEED and press ENTER
The following
character display
appears
The regulator area should also be set for the potentiometers to be used. Use the
plus/minus buttons in the controller to indicate a minimum value and a maximum
value.
This applies to non--synergic mode. In synergic mode. +-- 10 V is set on ANALOG 1
in relation to the selected synergic line. ANALOG 2 wire feed speed is set as in
non--synergic mode.
bu12d04a
MIG/MAG -- REMOTE CONTROLS
DIGITAL OP:
ANALOG 1:
ANALOG 2:
RANGE ON INPUTS:
ANALOG 1. DIG +/--
CONFIGURATION -- REMOTE CONTROL
DIGITALLY MANEUVERED:
ANALOGUE 1:
ANALOGUE 2:
RANGE ON INPUTS:
ANALOGUE 1 MIN:
MAX
ANALOGUE 2 MIN:
MAX
- - 55 - -
NONE
VOLTAGE
5--PROG
VOLTAGE
NONE
MIN: # 8.0 V
MAX 60 V
*
QUIT
NONE
WIRE SPEED
5- -PROGRAM
VOLTAGE
WIRE FEED SPEED
# 8.0 V
60 V
*
# 38 in/min
635 in/min
*
QUIT
ENTER
ENTER