ESAB PUA 1 Manual page 62

The following weld parameters are adjustable:
for MIG
S
Wire feed speed
S
and
Voltage
S
for STICK
S
Welding current
S
for TIG
S
Welding current
S
for Arc air gouging
S
Voltage
S
Limits for parameter adjustment are set in the following way.
A plus value (upper limit) and a minus value (lower limit) are given for each
parameter, where the reference is made up of the weld data set--up's original setting.
Position the cursor
on the line for the
current weld
parameter.
e.g. VOLTAGE.
Use the plus/minus buttons to indicate the desired value for the upper and lower
limits.
9.2.8.2 Double start signals
With this alternative, the MIG wire feed unit can be started from the TIG card
(universal).
It also enables start of the TIG torch from the wire feed unit.
This function can be useful in mechanized applications.
bu12d04a
GENERAL DEFAULTS -- FASTMODE
SOFT KEY NUMBER:
VOLTAGE:
WIRE SPEED:
ASSOCIATED WELD DATA:
DIP/SPRAY. Fe, CO2,
CONFIGURATION -- GENERAL DEFAULTS
FAST MODE LIMITS
DOUBLE START SOURCES
TRIGGER WELD DATA SWITCH
- - 62 - -
1
# + 0.0 V
-- 0.0 V
*
# + 0.0 in/min
-- 0.0 in/min
*
16
0.045"...
QUIT
OFF
QUIT ENTER