Table of Contents
Advertisement
The following dialogue box appears in the character display during upgrading.
The following appears in the character display when the upgrade is complete.
All selected units have now been upgraded.
The weld current source must be restarted in order to use the weld equipment.
Turn the switch for line voltage to position 0.
S
Turn the switch for line voltage to position 1.
S
Make sure that the line voltage is disconnected to the weld current
source during upgrading. If this occurs too early during the upgrade you must
call an ESAB service technician.
bu12d04a
SOFTWARE UPGRADE
DO NOT SWITCH OFF THE EQUIPMENT DURING THIS
PROCESS!!
UPGRADING POWER SOURCE.......
23% Compl.
SOFTWARE UPGRADE
SUCCESSFUL UPGRADE
YOU MAY NOW RESTART THE EQUIPMENT
- - 77 - -
Advertisement
Table of Contents
