ESAB PUA 1 Manual page 60

Place the cursor at
MOTOR POWER.
Press ENTER to
call up a list of
options.
Place the cursor on the row for the selected
motor power. See the table for wire type--motor
power in the user manual for MLC 30C. Press ENTER.
Wire speed
The stop wire feed speed is the wire speed at which the power source is turned off.
This is to make as neat a stop as possible, without burning the contact tip.
If welding at 511 in/min. for example, the stop limit can be set to 393 in/min. This
means that the wire feed unit stops and the power source is turned off when the wire
speed falls below 393 in/min.
This prevents burning of the contact tip.
If welding at 118--157 in/min. set the stop speed at a lower value, such as 39 in/min.
Values may be set from 28 to 393 in/min.
Place the cursor on
STOP WIRE FEED
SPEED.
Step with one of
the plus/minus
buttons to the
settings value.
Press ENTER.
bu12d04a
MIG DEFAULTS SETTINGS -- MLC 30C
MOTOR POWER
STOP WIRE FEED SPEED
MIG DEFAULTS SETTINGS -- MLC 30C
MOTOR POWER:
STOP WIRE FEED SPEED:
- - 60 - -
1.0 A
28 in/min
QUIT ENTER
1.0 A
1.25 A
1.50 A
1.75 A
1.0 A
28 in/min
QUIT ENTER