ESAB PUA 1 Manual page 24

Crater Fill
Begin by choosing whether or not you want to use the crater fill function. If you
choose to use crater fill you will then also have to set the crater fill time and wire feed
speed.
Place the cursor on
the row for
CRATER FILL and
press ENTER to
view a list of
alternatives.
Choose YES.
Crater Fill Time
Position the cursor
on the line TIME.
Set it to 1.5 s using
one of the
plus/minus buttons.
Final Wire Feed Speed
This is used to set the wire feed speed that will be used when crater fill is complete.
Position the cursor
on the line FINAL
WIRE SPEED.
Set it to 118 in/min
(3.0 m/min) using
one of the
plus/minus buttons.
bu12d04a
STOP DATA SYNERGIC MODE
CRATERFILL
TIME :
FIN. WIRE SPEED:
BURNBACKTIME:
GASPOSTFLOW:
CRATR HOT
D D
FILL START
STOP DATA SYNERGIC MODE
CRATERFILL
TIME:
FINAL WIRE SPEED:
BURNBACKTIME:
GASPOSTFLOW:
CRATR HOT
D D
FILL START
STOP DATA SYNERGIC MODE
CRATERFILL
TIME:
FINAL WIRE SPEED:
BURNBACKTIME:
GASPOSTFLOW:
CRATR HOT
D D
FILL START
- - 24 - -
YES
1.5 s
393 in/min
0.12 s
0.5 s
4- -
STROKE QUIT
YES
1.5 s
393 in/min
0.12 s
0.5 s
4- -
STROKE QUIT
YES
1.5 s
118 in/min (3.0 m/min)
0.12 s
0.5 s
4- -
STROKE QUIT