ESAB PUA 1 Manual page 25

Burnback Time
Position the cursor
on the line
BURNBACK TIME.
Set it to 0.11 s using
one of the
plus/minus buttons.
Gas Post- - Flow
Use this to set the time for which the gas continues to flow after welding is complete.
Position the cursor
on the line GAS
POST--FLOW. Set
it to 2.0 s using one
of the plus/minus
buttons.
This completes the stop data settings and means that all the weld data settings for
MIG welding have been entered.
bu12d04a
STOP DATA SYNERGIC MODE
CRATERFILL
TIME:
FINAL WIRE SPEED:
BURNBACKTIME:
GASPOSTFLOW:
CRATR HOT
D D
FILL START
STOP DATA SYNERGIC MODE
CRATERFILL
TIME:
FINAL WIRE SPEED:
BURNBACKTIME:
GASPOSTFLOW:
CRATR HOT
D D
FILL START
- - 25 - -
YES
1.5 s
118 in/min (3.0 m/min)
0.11 s
0.5 s
4- -
STROKE QUIT
YES
1.5 s
118 in/min (3.0 m/min)
0.11 s
2.0 s
4- -
STROKE QUIT