User--Defined Synergic Lines For Mig - ESAB PUA 1 Manual

9.6 User- -Defined Synergic Lines for MIG
It is possible to create custom synergic lines with regard to the wire feed speed and
voltage. A maximum of ten such synergic lines can be saved.
Creating a new synergic line is done in two stages.
1. Define the new synergic line by stating a number of voltage/wire feed speed
co--ordinates, see steps A--D in the following figure.
2. Specify to which wire/gas combination the synergic line applies.
9.6.1 Indicate Wire/Voltage Co- -ordinates
Four co--ordinates are required to create a synergic line for dip/spray method, and
two co--ordinates are required for pulse method. These co--ordinates must then be
saved under special weld data numbers in the weld data memory.
Do as follows:
1. Call up the main menu and choose the MIG method (dip/spray or pulse) to which
the synergic line applies.
2. Enter the desired values of voltage and wire feed speed for the first co--ordinate.
3. Call up the memory menu and save the first co--ordinate as weld data number
96.
The four co--ordinates for a dip/spray line must be saved as numbers 96. 97.
S
98 and 99.
In addition:
each weld data number must contain higher values of voltage and wire
S
feed speed than the weld data number that precedes it.
the parameters inductance. regulator type and Hot start voltage must
S
have the same values in all four weld data numbers.
The two co--ordinates for a pulse welding line must be saved as numbers 96
S
and 97. In addition:
a higher weld data number must contain higher values for voltage, wire
S
feed speed, pulse frequency, pulse amplitude and background current
than the weld data number that precedes it.
bu12d04a
MAIN MENU
AUXILIARY FUNCTIONS
CUSTOM SYNERGIC PARAM.
Voltage
C D
B
A
- - 71 - -
Wire feed