Qiagen PyroMark Q96 ID User Manual page 57

Be sure to observe all federal, state, and local environmental
regulations for the disposal of laboratory waste.
The following item is required:

Procedure:
1. Ensure that no vacuum is applied to the Vacuum Prep
2. Discard any solutions left in the troughs.
3. Rinse the troughs with high-purity water, or replace them,
4. Empty the waste container.
5. If the vacuum workstation must be cleaned (e.g., dust or
PyroMark Q96 ID User Manual 01/2016
High-purity water (Milli-Q 18.2 MΩ x cm or equivalent).
Tool, i.e., the vacuum switch is closed (Off), and the
vacuum pump is switched off.
if necessary.
Note: The cap can be removed without disconnecting
the tubing.
spillage), follow the instructions in Section 7.7.
Operating Procedures
5-25