Reinstalling The Pyromark Q96 Id: Stand Alone; Reinstalling The Pyromark Q96 Id: Network Installation - Qiagen PyroMark Q96 ID User Manual

Installation Procedures
9. At the new site, unpack the instrument and remove the
10. Follow the reinstallation procedures in Section 4.4 for
4.4 Reinstalling the PyroMark Q96 ID: Stand
alone
When delivered, the PyroMark Q96 ID is configured as a
peer-to-peer network. The operator's computer acts as the
host and PyroMark Q96 ID as the guest.
Install a stand-alone system as follows:
1. Identify the cable marked "Cross-connected TP" provided
2. Connect the other end of the Ethernet cable to the
3. Connect mains power as per Section 4.6.
4.5 Reinstalling the PyroMark Q96 ID:
Network installation
The operator's computer is configured with a built-in Ethernet
port to connect to the PyroMark Q96 ID and an external USB
adaptor to connect to a Local Area Network (LAN).
The main advantages of connecting the PyroMark Q96 ID to a
LAN are:




4-4
transport protection block from under the instrument lid.
stand-alone installation or Section 4.5 for network
installation.
with the PyroMark Q96 ID. Connect one end of this
cable to the network connector on PyroMark Q96 ID
("net").
Note: The "keyboard", "mouse", and "monitor"
connectors are for the use of QIAGEN Field Service
Specialists only.
network card connector on the operator's computer.
Easier access to run data files
Assays can be set up and analyzed on office computers
Data such as SNP entries can be shared between
different users
Access to LAN printing resources
PyroMark Q96 ID User Manual 01/2016