APRILIA Tuono V4 1100 Factory Service Station Manual page 81

Tuono V4 1100 Factory
•
Release from the supports the connec-
tors of the front bank coils located on
the filter housing base.
•
Disconnect the lower injector wiring
harness from the bracket located on
the filter housing base.
•
Remove the filter housing base.
Air filter housing installation
To install the filter housing, carry out the removal
procedure in reverse order, paying particular at-
tention to the following operations:
CLAMP PRE-FITTING
•
Place a suitably sized clamp on the en-
gine wiring harness next to the grey
taping and secure it to the filter housing
base.
•
Do not tighten the clamp to facilitate the
connection of the front bank coil con-
Maintenance
MAIN - 81