APRILIA Tuono V4 1100 Factory Service Station Manual page 499

Tuono V4 1100 Factory
Pos. Description
3 Stand fastening pin
4 Fastener nut of side stand
Side stand
In order to remove the side stand, the side fairings,
fuel tank and front sprocket cover must be re-
moved beforehand.
Then proceed as described:
•
Disconnect the connector (1) of the
side stand sensor and remove the ca-
ble tie (2) to free the wiring harness
from the subframe.
•
Remove the rubber cable retainer clip
(3) and the spiral cable protector (4) to
free the wiring harnesses.
•
Remove the fastener screw of the met-
al cable retainer (5) and the cable tie
(6) securing the wiring harnesses to
the chain guide.
•
Free the wiring harness of the side
stand switch completely.
Type Quantity
- 1
- 1
Torque Notes
... Nm (... lbf ft)
... Nm (... lbf ft)
CHAS - 499
Chassis
-
-