Tuono V4 1100 Factory
•
Remove the brake calliper.
Installing
To install the rear brake calliper, proceed as de-
scribed:
•
Fit the rear brake calliper on the disc.
•
Fit the two fastener screws of the brake
calliper and tighten to the specified tor-
que.
•
Protect the brake calliper adequately,
connect the brake pipe, fit the special
screw and then tighten the screw to the
specified torque.
•
Fill with oil and bleed the system.
•
Check the correct functioning of the braking system
Braking system
BRAK SYS - 533