APRILIA Tuono V4 1100 Factory Service Station Manual page 378

Engine
Crankcase
Pos. Description
1 Stud bolts
2 Flanged hex cap screw
3 Flanged hex cap screw
4 Flanged hex cap screw
5 Flanged hex cap screw
6 Gearbox control rod support SHC fix-
ing screws
7 Flanged TE screw fixing fuel rail
gearbox lubrication
8 TB TORX fixing screw of the con-
necting rods lubrication nozzles
9 TSPEI screw fixing bearing stop
plates
10 Stud bolt
11 SHC screw
12 Special nut
13 Flanged nut
ENG - 378
C
RANKCASE
Type Quantity
M10 18 20 Nm (14.75 lbf ft)
M8x70 4 25 Nm (18.44 lbf ft)
M6x50 8 10 Nm (7.38 lbf ft)
M8x35 1 25 Nm (18.44 lbf ft)
M8x50 3 25 Nm (18.44 lbf ft)
M6x35 2 10 Nm (7.38 lbf ft)
M6x12 2 10 Nm (7.38 lbf ft)
4x12 4
M6x16 2 10 Nm (7.38 lbf ft)
M6 1 Bring to 33mm from the
M6x40 1 10 Nm (7.38 lbf ft)
- 1 10 Nm (7.38 lbf ft)
M10 6 15 + 20 Nm (11.06 +
14.75 lbf ft) + 60° + 60°
Tuono V4 1100 Factory
Torque Notes
Loct. 270
Lubricate the head
and under the head.
Lubricate the head
and under the head.
Lubricate the head
and under the head.
Lubricate the head
and under the head.
Lubricate the head
and under the head.
Pre-impregnated
screw and in ab-
sence Loct.2045
5 Nm (3.69 lbf ft) Pre-impregnated
screw, in absence
Loct.2045
Loct. 243
Loct. 648
surface
Lubricate the head
and under the head.
Lubricate the head
and under the head.
Use the sequence:
1) Pre-tighten to 15
Nm (11.06 lbf ft); 2)
Tighten to 20 Nm
(14.75 lbf ft); 3)
Tighten applying an
angle of 60° +/- 2; 4)
Repeat the opera-
-