APRILIA Tuono V4 1100 Factory Service Station Manual page 541

Tuono V4 1100 Factory
•
Remove the stop ring (2).
BEFORE DISCONNECTING THE PIN (3), CHECK THE PO-
SITION OF THE SAFETY SPRING (4); IT MUST BE POSI-
TIONED IN THE SAME WAY ON REASSEMBLY.
•
Remove the pin (3) and recover the
safety spring (4).
•
Remove the two pads (5) and recover
the soundproofing plates.
DO NOT OPERATE THE BRAKE LEVER ONCE THE BRAKE
PADS HAVE BEEN REMOVED, AS THIS MAY FORCE THE
PISTONS OUT FROM THEIR SEATS AND ALLOW BRAKE
FLUID TO ESCAPE.
•
If worn, replace the anti-vibration plates.
Installing
•
Insert two new pads and the vibration-
damping plates, placing them so that
the holes are aligned with the calliper
holes.
UPON REFITTING, MAKE SURE THE ARROWS ON THE VI-
BRATION-DAMPING PLATES FACE THE DIRECTION OF
ROTATION OF THE WHEEL.
CAUTION
Braking system
BRAK SYS - 541