Engine from vehicle
•
Extract the pin until it allows screwing
at the specified torque the two adjuster
screws on the right side of the chassis.
•
Refit the pin and after having inserted
the upper rear screw together with the
washers, tighten al screws to the speci-
fied torque.
•
Remove the engine support and insert
the rear bank manifolds equipped with
new gaskets.
•
Insert the locking nuts and screw them
partially to facilitate the subsequent op-
erations for the assembly of the ex-
haust system.
ENG VE - 286
Tuono V4 1100 Factory