Table of Contents
Advertisement
Tuono V4 1100 Factory
TABLE A - IGNITION RELAY PRE-ASSEMBLY
The positive battery cable must be connected to
the hole identified by the letter B (Battery) using
M5x8 screw
1. Starter relay
2. Battery positive cable pole (identified by the let-
ter "B")
3. Vehicle wiring starter motor cable pole (identi-
fied by the letter "M")
TABLE A1 - IGNITION RELAY PRE-ASSEMBLY
If the battery positive cable is not connected to the
ignition relay correctly it may result in fires and in-
correct vehicle operation.
1. Ignition relay
2. Battery positive cable
TABLE A2 - IGNITION RELAY PRE-ASSEMBLY
After having correctly placed the cables, tighten
the two screws to the specified torque.
TABLE B - PROCEDURE FOR THE CORRECT
OPENING OF THE ABS CONTROL UNIT CON-
NECTOR
•
GENTLY press with a screwdriver at
the point marked by the arrow and pull
up the lever with your finger
TABLE C - PROCEDURE FOR CORRECT ABS CONTROL UNIT CONNECTOR INSERTION
The initial position of the connector fastener lever must be as shown in the figure
Electrical system
ELE SYS - 141
Hide quick links:
Advertisement
Table of Contents
