APRILIA Tuono V4 1100 Factory Service Station Manual page 471

Tuono V4 1100 Factory
•
Act on the threaded pin (1) with a hex-
agonal wrench, blocking rotation Un-
screw the DAX nut (2) and remove it
•
Repeat the operation to remove all the
nuts and related pins.
•
Remove the crown gear support (3)
and the flange (4)
•
After the disassembly of the rear
wheel, pay particular attention to the
locking screws of the flexible coupling
holder, which must be perfectly seated.
If anomalies are noted it is necessary
to proceed with the REPLACEMENT of
the complete rim.
WARNING
DO NOT REMOVE THE LOCKING SCREWS OF THE FLEXIBLE COUPLING HOLDER, OR CHECK
THE TIGHTENING TORQUE.
ANY MAINTENANCE INTERVENTION ON THESE COMPONENTS MAY CAUSE A VEHICLE MAL-
FUNCTION.
FITTING
•
Fit the sprocket (3) and the flange (4)
on the crown gear
Chassis
CHAS - 471