APRILIA Tuono V4 1100 Factory Service Station Manual page 531

Tuono V4 1100 Factory
It is important to check that all the tone wheels (2) are always clean. Otherwise,: delicately remove any
dirt residues using a cloth or wire brush. Avoid using solvents, abrasives and air or water jets directly
on the tone wheel (2).
REPLACING THE PHONIC WHEEL SENSOR
Disconnect the tone wheel sensor connector (1) from the main wire. Unscrew and remove the screw
and remove the tone wheel sensor (1).
CAUTION
BEFORE REFITTING, MAKE SURE THAT THE FACING SURFACES BETWEEN THE SENSOR (1)
AND THE SEAT ITSELF DO NOT SHOW SIGNS OF DAMAGE AND ARE COMPLETELY CLEAN.
ALWAYS CHECK THE DISTANCE BETWEEN THE SENSOR (1) AND THE TONE WHEEL (2).
Rear brake calliper
Pos. Description
1 ABS sensor fixing screw
2 Screws fastening brake calliper to
mount
R
EAR BRAKE CALLIPER
Type Quantity
M5x15 1
M8 2
Braking system
Torque
8 Nm (5.90 lbf ft)
25 Nm (18.43 lbf ft)
BRAK SYS - 531
Notes
-
-