APRILIA Tuono V4 1100 Factory Service Station Manual page 446

Suspensions
•
Tighten the nut as much as possible.
•
Fully tighten the compression/rebound
adjusters.
•
Insert the cover and tighten until it
stops.
•
Remove the dedicated tools.
•
Screw the cover in the sleeve to the
prescribed torque.
TUONO V4 1100 FACTORY
NOTE
THE FOLLOWING OPERATIONS REFER TO THE OHLINS FORKS.
•
Place the sleeve upright in a vice fitted
with protection shoes.
•
Compress the sleeve in the stanchion.
Place a support under the stanchion in
order to leave it compressed.
•
Pour part of the fork oil into the sleeve.
•
Wait a few minutes until the oil fills all
the ducts.
•
Pour the remaining oil.
•
Pump out oil a few times.
•
Measure the air gap between the oil
level and the rim.
THE SLEEVE MUST BE PERFECTLY UPRIGHT IN ORDER
TO MEASURE THE CORRECT OIL LEVEL. THE OIL LEVEL
MUST BE THE SAME IN BOTH STANCHIONS.
Specific tooling
AP8140149 Guard for assembly operations
Oil level: 181 mm (7.13 in) (from the sleeve edge, without a spring and pre-fill pipe).
SUSP - 446
Tuono V4 1100 Factory