APRILIA Tuono V4 1100 Factory Service Station Manual page 147

Tuono V4 1100 Factory
TABLE G1 - REAR BRAKE SWITCH
•
Pass the rear brake switch wiring har-
ness through the cable gland inside the
chassis on the right side.
TABLE H - OBD2 CONNECTOR
•
The OBD2 wiring harness connector
must pass from the inside of the vehicle
to the outside and must be inserted in
the specific support, as indicated.
TABLE I - AMP CONNECTOR
•
After having engaged the connector in
the support, pass the wiring harness
inside, between the saddle column
frame and the under-tail fairing.
TABLE J - AMP CONTROL UNIT (IF PRESENT)
•
After having secured the control unit,
connect the connector with its counter-
part.
Electrical system
ELE SYS - 147