APRILIA Tuono V4 1100 Factory Service Station Manual page 445

Tuono V4 1100 Factory
Oil level: 90- 2mm (3.54- 0.08 in) (from sleeve
rim, without spring and total cap).
THE SLEEVE MUST BE PERFECTLY UPRIGHT IN ORDER
TO MEASURE THE CORRECT OIL LEVEL. THE OIL LEVEL
MUST BE THE SAME IN BOTH STANCHIONS.
Characteristic
Fork oil
463 +/- 5 cC (28.25 +/- 0.30 cu.in) (same quantity
for both stems)
•
Insert the spring.
CAUTION
PROCEED WITH CAUTION WHEN INSERTING THE
SPRING AND ENSURE THAT THE PART WHERE THE SPI-
RAL IS MORE COMPRESSED IS FACING DOWNWARDS.
•
Insert the washer that will be supported
on the spring.
•
Insert the nut on the plunger and hand
tighten it
•
Position the pre-loading tube.
•
Screw the special tool onto the plunger
shaft and maintain it in the raised po-
sition as long as possible, in order to
insert a wrench on the nut, while com-
pressing the spring.
Specific tooling
020890Y Support rod of pumping unit stan-
chion
AP8140147 Spacer retaining device
Suspensions
SUSP - 445