APRILIA Tuono V4 1100 Factory Service Station Manual page 321

Tuono V4 1100 Factory
Magneto flywheel removal
•
Remove the flywheel cover.
•
Block flywheel rotation using the spe-
cific tool.
THE SPECIFIC TOOL MUST BE MODIFIED FOR
USE ON THIS ENGINE, WIDENING THE CEN-
TRE HOLE BY THE AMOUNT NECESSARY TO
ALLOW THE TOOL TO FIT COMPLETELY ON-
TO THE FLYWHEEL.
FASTEN USING THE THREE SCREWS INDICA-
TED.
•
Unscrew and remove the screw.
Specific tooling
020914Y Flywheel stop
•
Remove the tool for blocking flywheel
rotation.
•
Insert a SHC M10x20 screw into the
crankshaft hole, which will act as a
mounting base for flywheel extraction.
•
Remove the flywheel using the specific
extractor.
•
Collect the SHC M10x20 screw.
Specific tooling
020913Y Flywheel extractor
•
When removing the flywheel with the extractor tool, make sure that you retrieve the key to
prevent it from falling into the interior of the engine.
See also
Removing the flywheel cover
Engine
ENG - 321