Removing Drives For Sbx/Fbx/Nbx - Hitachi DKC910I Installation Section

Hitachi Proprietary
Rev.1
INST(IN)05-01-30

5.1.2 Removing Drives for SBX/FBX/NBX

1. Remove the Front Bezel. (See "In Case of SBX/UBX/FBX/NBX" (INST(GE)04-05-20).)
2. Remove the Drive or a dummy (Drive).
Pull the stopper of the handle toward you to have the lock off, tilt the handle toward you, and then
remove the Drive by pulling it out taking care not to apply a shock to it.
Pressing the latch at the lower part of the dummy (Drive) to the direction of the arrow, hold the upper
part and pull it out, and then remove it.
3. Keep the Drive of dummy (Drive) that has been removed temporarily in the component safekeeping
container at the location shown on the address label with its handle returned to its original state (locked
by the stopper). It is to be installed in the Storage System after the Drive is mounted on the rack frame.
Figure 5-2 Removing Drive (SBX/NBX)
Address label
Safekeeping box
Drive
The procedure for removing a Drive
Drive
Handle
Stopper
The procedure for removing a dummy (Drive)
Dummy (Drive)
Latch
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
[INST(IN)05-01-30]