Installing Drive; Installing Drive For Ubx - Hitachi DKC910I Installation Section

Hitachi Proprietary
Rev.1
INST(IN)08-01-20

8.1 Installing Drive

The drive installation procedure for UBX is different from that for SBX/FBX/NBX.

8.1.1 Installing Drive for UBX

1. Pull the parts out of the Drives safekeeping of component.
Be sure to install the removed Drive to the original bay.
2. Insert the Drive into the position (address) where it was by holding it with the handle.
NOTE : When handling the Drive, hold the rail side because the SHIELD SPRING is subject
(1) Open the handle fully and fit the Drive in the guide rail and slide it in the direction shown by the
arrow.
(2) Push it in until it reaches the position where a hook of the handle can be entered into the square
hole on the frame.
(3) Pull the stopper lightly and close the handle, and then have the lock on by pressing the stopper.
NOTE : If the handle is closed in the state in which its hook cannot be entered into the square
3. Pull the handle lightly to make sure that the Drive cannot be pulled out.
4. Attach the dummy (Drive) to the each Drive slot in which no Drive is installed.
Insert it into the slot slowly so that the latch part of the dummy (Drive) comes to the left side.
Figure 8-1 Installing the Drive/Dummy (Drive) (UBX)
Guide rail
Drive
Address label
Safekeeping box
to breakage.
hole, the Drive cannot be installed correctly because it runs into the frame of the
Storage System.
The procedure for installing a Drive
Stopper
The procedure for installing a dummy (Drive)
Screw box
Square hole
Hook
SHIELD SPRING
Handle
Dummy (Drive)
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
Drive
Rail
[INST(IN)08-01-20]