Hitachi DKC910I Installation Section page 81

Hitachi Proprietary
Rev.1
INST(IN)07-01-40
(3) Fix the stopper (L) with the two binding screws while pressing it downward.
(4) Fix the stopper (R) with the two binding screws while pressing it downward.
Figure 7-4 Fixing Stoppers (for Rail Type without a Stopper)
Pressing the stopper
downward
Pressing the stopper downward
Binding
screws
(5) Check that the top surface of the Controller Chassis is fit on the stopper (L) and the stopper (R)
without gaps.
(The stoppers might be rotated and raised by tightening the binding screws.)
NOTE: When the installation of the stoppers is difficult because the space between the
Stopper (L)
Stopper (L)
Controller Chassis and the Chassis above it is too narrow, contact the Technical
Support Division to resolve the problem.
Pressing the stopper
downward
Stopper (R)
Pressing the stopper downward
Stopper (R)
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
Rack frame
rear side
Binding
screws
[INST(IN)07-01-40]