Connecting Sas Cables/Nvme Cables; Precautions When Connecting Sas Cables/Nvme Cables - Hitachi DKC910I Installation Section

Hitachi Proprietary
Rev.1
INST(IN)09-04-10

9.4 Connecting SAS Cables/NVMe Cables

Connect a Controller Chassis and a Drive Box or a Drive Box and another Drive Box with the SAS cable or
the NVMe cable.

9.4.1 Precautions when Connecting SAS Cables/NVMe Cables

NOTE : • The rubber cap is attached to the SAS connector.
Figure 9-33 Note on Connecting the SAS Cable
DKC (Rear view)
UBX (Rear view)
SBX/FBX (Rear view)
Remove the rubber cap before installing the SAS cable.
• The plugs of the SAS cable have no distinction between IN and OUT. They can be
inserted in both IN and OUT.
• Be careful when connecting the SAS cable. The tip of the SAS cable may be
inserted into a gap between the SAS port and the chassis and damaged.
• Check that optional cable latch clicks and the cables are surely connected.
Gap
Tip of the SAS cable
between the SAS port and the chassis
Gap
: SAS port
Tip of the SAS cable
SAS cable
between the SAS port and the chassis
SAS cable
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
[INST(IN)09-04-10]